Bomgar Jump Technology enables privileged users to connect to an unattended remote computer to start a session without end-user assistance. Dependent upon your permissions, you may Jump to any computer on your LAN/VPN or on a network with a Jumpoint agent. To Jump to a non-Windows computer or a system which is not on a network, see Use Jump Clients to Access Unattended Computers.
Use a Jumpoint for Unattended Access to Computers on a Remote Network
Note: Jumpoint is only available for Windows systems. Jump Clients are needed for remote access to Mac or Linux computers. To Jump to a Windows computer without a Jump Client, that computer must have Remote Registry Service enabled (disabled by default in Vista) and must be on a domain. If you need to access remote computers via Jumpoint when no user is available, make sure your account permissions are set either to disable prompting or to default to Allow. You cannot Jump to a mobile device, though Jump Technology is available from mobile Bomgar consoles.
To Jump without a pre-installed client, open the Jump to… dialog from:
- The Support menu of the representative console
- The Start button at the top of the representative console
- The Jump To button at the top of the representative console
From the Jumpoint dropdown, select the network that hosts the computer you wish to access. Depending on your account permissions, you can Jump to a system on your local network or a network on which a Jumpoint is installed.
Enter the hostname or IP address of the system you wish to access. Alternatively, if network browsing is enabled from the /login > Jump > Jumpoint page, you can click the [...] button to browse the directory tree.
Once you have located the computer you wish to access, click Jump.
You must provide administrative credentials to the remote computer in order to complete the Jump. The administrative rights must be either a local administrator on the remote system or a domain administrator.
The client files will be pushed to the remote system, and a session will attempt to start. Depending on the session permissions, the end-user may be prompted to accept or deny the session. If no response is received within a defined interval of time, the session will either start or cancel, again depending on the session permissions.
Note: If you need to access systems through a Jumpoint when no user is available, make sure the public portal permissions and your account permissions are set either to disable prompting or to default to Allow.