Change or Disable the Authenticator App in Bomgar Connect
Change the Authenticator App
Once you have set up two-factor authentication for your account using a specific app, you still have the option of changing to a different one. To do so, go to /login > My Account > Two Factor Authentication and click Replace Authenticator App.
On the next screen, enter your password and the code on the app, and click Continue.
You are taken to the initial setup screen. Repeat the initial setup process but this time with the new authenticator app you wish to use. If this is an app you have already used and registered, simply enter the code. If it is a new app, you must to scan the QR code again.
When done, click Replace App. The previous app is disabled, and you must use the new app selected at the next login. You can always change back or select a different one by repeating the steps above.
Note: If you decide to replace your current app, you must begin using a new one. It is not possible to disable two-step authentication after this point.
Disable Authenticator App - User Side
If you are not required by your administrator to use two-factor authentication, you can disable this feature.
Due to the enhanced level of security provided by this feature, it is NOT a best practice to disable two-factor authentication.
To disable two-factor authentication, go to /login > My Account > Two Factor Authentication and click Deactivate Authenticator App. Enter your password and code on the app, and then click Deactivate. A message displays confirming the feature has been deactivated.
Disable Authenticator App - Admin Side
As an administrator, you may remove a user's current authenticator app. Go to the user's settings page, and under Account Settings > Two Factor Authentication, select Remove Current Authenticator App. Scroll to the bottom of the page and click Save. The next time the user logs in, only their userame and password is needed to log into the administrative interface and the Bomgar representative console.
Note: An administrator may remove a user's current authenticator app whether the user is required to use two-factor authentication or simply chooses to use it.
If a user's device used for two-factor authentication is lost or reset, a Bomgar admin must remove that user's current authenticator app and require that the user set up two-factor authentication again.